HP Deskjet 6980 Serie Guide D'installation page 16

Additional computers
You must install the printer software on each computer that will use the printer. Follow
steps 5 through 7 above to install the printer software on other network computers.
Advanced setup
For instructions on configuring the printer to operate on ad hoc networks other than
the hpsetup factory default, visit the HP Web site at www.hp.com/support .
802.11g
The printer defaults to 802.11b in ad hoc mode in order to be compatible with the
widest assortment of 802.11 devices. If your network is made up of only 802.11g
devices, then you might want to configure the printer to operate in 802.11g mode in
order to optimize network performance.
Follow these steps to configure the printer to operate in 802.11g mode while
connected to an ad hoc network:
Open the printer embedded Web server (EWS). For help opening the EWS, see
1.
the network guide.
2. Click the Networking tab.
Under the Connections heading, click Wireless (802.11 ).
3.
4. Click the Advanced tab.
Scroll to the bottom of the Web page, and clear the In an ad hoc network use
5.
802.11b behavior
Click the Apply button, and then close the EWS.
6.
Macintosh users
Ad hoc or computer-to-computer
1. Verify the printer is powered on and idle, and that the blue Wireless Status light is
illuminated. If the Wireless Status light is not illuminated:
a. Open the top cover of the printer.
Press the SES button twice (two presses within 3 seconds). The wireless radio
b.
(and the Wireless Status light) will turn on and stay on.
Close the top cover.
c.
2. Make sure the Airport protocol is turned on. To configure the Airport protocol,
open System Preferences , double-click Network , and then choose Airport from the
pop-up menu.
Show
3. Insert the printer software CD in the computer CD-ROM drive, and then double-
click the CD desktop icon.
4. Double-click the HP Deskjet 6980 installer icon, and then follow the onscreen
instructions.
14
check box.
HP Deskjet 6980 Series Setup Guide