Electrical Connection - Hella JUMBO 320 FF Instructions De Montage

EN

ELECTRICAL CONNECTION

Install relay with connection terminals
pointing downwards so that they are
protected against splashing water.
If required, and legally permissible,
install switch in dashboard.
Lay and connect wires according to
circuit diagram.
According to circuit diagram
auxiliary lamps are switched on toge-
ther with the existing main beams.
23
According to circuit diagram
auxiliary lamps can be switched on
in addition to the main beams with a
separate switch.
According to circuit diagram
the position lamps are wired up and
switched on together with the parking
light.
Check lights, tighten connection wires
securely.
Have the driving lamps adjusted
at a workshop or service station.
Only properly adjusted lamps provi-
de optimum illumination.
The use of the enclosed protective
caps (enclosed where applicable) is
not permissible in areas governed
by German Traffic Laws.
the
the
III
One more tip:
Keep the lenses clean. Dirt can absorb
up to 80% of the light. You drive more
safely when you can see and be seen
well. Do you have spare bulbs and
fuses in your vehicle?
Check that the lighting system is
working perfectly!
If you have questions or installa-
tion problems, please call the HEL-
LA Service, wholesaler, or turn to
your garage.