Publicité
Valve Stem Adapter
Screws
Escutcheon
3. Install the Trim
Firmly press the valve stem adapter onto the valve stem.
Secure the valve stem adapter to the valve with the correct length
screw, as selected in the "Install the Valve Stem Adapter" section
of this guide.
Align the holes on the front plate assembly and the valve.
NOTE: Be sure to select the correct length screw for your
application.
Secure the front plate assembly to the valve with two screws. Do
not overtighten.
Visually inspect the front plate assembly to ensure that the foam
seal is completely covering the wall opening. If not, stop the
installation and repair the wall opening.
Place the escutcheon against the wall. The drain holes in the
escutcheon should be positioned downward.
NOTE: If the handle does not engage the valve or the escutcheon
does not tighten to the wall, replace the valve stem adapter with an
adapter of appropriate length.
Care and Cleaning
For best results, keep the following in mind when caring for your
KOHLER product:
Kohler Co.
Screw
Front Plate Assembly
7
Handle Assembly
1204800-2-A
Publicité
