Hotpoint HTM 1720 V Doppia Mode D'emploi page 20

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
Avoid storing unwrapped food in
direct contact with internal surfaces
of the refrigerator or freezer
compartments.
Appliances could have special
compartments (Fresh Food
Compartment, Zero Degree
Box,...).
INSTALLATION
Installation and repairs must be carried out by a qualified technician, in
compliance with the manufacturer's instructions and local safety regulations.
Do not repair or replace any part of the appliance unless specifically stated in
the user manual.
Children should not perform installation operations. Keep children away
during installation. Keep the packaging materials (plastic bags, polystyrene
parts, etc.) out of reach of children, during and after the installation.
The appliance must be handled and installed by two or more persons. Use
protective gloves to unpack and install the appliance.
Be careful not to damage the floors (e.g. parquet) when moving the
appliance.
Install the appliance on a floor or support strong enough to take its weight
and in a placesuitable for its size and use.
After unpacking the appliance, make sure that it has not been damaged
during transport. In the event of problems, contact the dealer or your nearest
Aftersales Service.
The appliance must be disconnected from the power supply before any
installation operation.
During installation, make sure the appliance does not damage the power
cable.
To guarantee adequate ventilation, leave a space on both sides and above the
appliance.
The distance between the rear of the appliance and the wall behind the
appliance should be 50mm, to avoid access to hot surfaces. A reduction of
this space will increase the Energy consumption of product.
Only activate the appliance when the installation has been completed.
Wait at least two hours before switching the appliance on, to ensure that the
refrigerant circuit is fully efficient.
Make sure the appliance is not near a heat source.
In case not differently specified in
the specific booklet of product, they
can be removed, maintaining
equivalent performances.
C-Pentane is used as blowing agent
in the insulation foam and it is a
flammable gas.
20

Publicité

Table des Matières
loading

Table des Matières