Operation Mode - Bradley Verge LVQ Serie Manuel D'installation

LVQD1
Master Control Box: Operation Modes
Standby/Idle Mode
Standby/Idle mode is automatically activated when the WashBar is not in use. All of the sensors (soap, water, dryer) are active in
this mode. When any sensor is activated (soap, water, dryer or approach), the WashBar will exit Standby/Idle Mode.
LED Indicators
All blue dimmed
All blue
All Off
Only Soap LED solid red
Soap and water LED solid
red
Air and water LED solid red
Soap and air LED solid red
All LED solid red
Any Flashing Red LED

Operation Mode

Operation mode is the normal dispensing/washing/drying mode automatically activated when the WashBar is in use. All of the
sensors (soap, water, dryer) are active in this mode.
While in operating mode:
• The soap and water can activate at the same time but the dryer cannot activate at the same time as the soap and water.
• When dryer is active, disable water sensor closest to dryer.
• When a water sensor is still detecting an object after 30 seconds, the water will shut off and wait for a no-detect before
becoming ready again.
• To reset low soap, hold hand under soap for 13 seconds (see table below for low soap indicator LED).
• When a soap sensor is still detecting an object after 15 seconds, the soap will prime for 30 seconds or until a no-detect
occurs before becoming ready again.
• When a dryer sensor is still detecting an object after 30 seconds, the dryer will shut off and wait for no detect before
becoming ready again.
LED Indicators
All blue bright
Green bright
Only Soap LED solid red
Soap and water LED solid red
Air and water LED solid red
Soap and air LED solid red
All LED solid red
Any Flashing Red LED
20
Meaning
Default/normal
User option, See Configuration Mode
User option, See Configuration Mode
Low soap (Reset: Hold hand under soap sensor until red
LED turns off, approximately 13 seconds.)
Soap sensor board error
Air sensor board error
Both sensor boards error
Air sensor board error and low soap
Dryer, water or soap has timed-out. This is caused by a
obstructed sensor. Remove obstruction or wipe sensors with
microfiber cloth to prevent from scratching sensor. System
will return operational automatically once cleared.
Ready Mode
Dispensing soap, water or air
Low soap (Reset: Hold hand under soap sensor until red
LED turns off, approximately 13 seconds)
Soap sensor board error
Air sensor board error
Both sensor boards error
Air sensor board error and low soap
Dryer, water or soap has timed-out. This is caused by a
obstructed sensor.
2/4/2019
Meaning
Bradley • 215-1842 Rev. E; ECO 18-08-023
Installation
The dryer has a 1.5
second delay in this mode.
Solution
n/a
n/a
Refill soap.
Contact Bradley Technical Services.
Contact Bradley Technical Services.
Contact Bradley Technical Services.
Contact Bradley Technical Services.
Remove obstruction or wipe sensors
with microfiber cloth to prevent from
scratching sensor. System will return
operational automatically once
cleared.