Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
6
Bowl Mounting with WashBar (to Bracket and Wall)
WARNING Ensure bowl is completely
seated in the wall bracket
and securely fastened to
the wall at point A.
CAUTION Bracket is not
intended to support
the weight of bowl for
an extended period
of time. Be sure to
secure the bowl to the
wall using appropriate
fasteners.
7
Install P-Trap
Drain Adapter
8
Strainer and Drain Cap
WashBar removed for clarity.
Drain cap is labeled front and back. Be sure front
is facing the user. Top surface of drain cap should
be sloped away from user.
Position drain cap over trough strainer,
aligning tabs into drain. Push drain
A
cap down until drain cap is flush with
basin. Grommets should hold drain cap
securely against drain trough walls.
To remove drain cap, carefully slip flat
B
screwdriver into left or right hand corner
of drain cap and gently lift upwards.
Bradley • 215-1842 Rev. E; ECO 18-08-023
Position bowl above wall bracket.
A
Press firmly on the back of the bowl
to seat the bowl flange into the wall
bracket lip. Ensure bowl is level.
P-Trap
Secure the bowl to the wall anchors
B
using fasteners per the structural
rough-in requirement (supplied by
installer).
Front
2/4/2019
LVQD1
Note Angle of
Drain Cap
13
Publicité
Table des Matières
