Anti-Tamper Installation; Battery Positioning And Cables-Entry; Positioning Of Data Label - AVS Electronics SAT W Mode D'emploi

Anti-tamper Installation

Battery Positioning and cables-entry

2
1
1
1
2

Positioning of data label

Etichetta
Box anti-tamper must be connected to Sat W (s) Tamper
input or in series to (TT) output on Int W (s), taking care to
correctly install the anti-tamper kit.
Anti-tamper Installation
1. Drill on the wall on the corresponding hole on the
bottom of the box
2. Insert the screw into the hole on the wall and screw
down the spacer
3. Insert anti-tamper from outside onto the hole of the box
bottom
4. Firmly fix the box to the wall and check that the spacer
presses on the anti-tamper pushbutton spring
For positioning of back-up battery, refer to picture on
the left. If back-up battery is installed, supplying cables
1
must have a 0,5 mm diameter each
Cables entry:
1
Ref. 1 Cables entry on box bottom are in evidence
Ref. 2 Cables entry on high and low sides of box
bottom are in evidence
Data label of extension board has to be positioned on
the box bottom as per picture here on the left
- 23 -
E
N
G