Use And Maintenance - Simu CENTRIS veoHz M Notice Originale

14- CONTROL OF THE VISUAL COMMAND
threshold threshold threshold threshold
4 3 2 1
- If you feel that this very short range does not allow controlling the product appropriately, you can increase it (threshold 3 - threshold 4),
provided that the new radio range guarantees an exclusively visual command.
- If you feel that this very short range does not allow visually controlling the product, you can decrease it (threshold 1).
CHANGING THE RADIO RANGE (THRESHOLDS 1 - 2 - 3 - 4)
If the transmitter's default range is appropriate (threshold 2), do not perform this step.
- First remove the rear screw on the transmitter to quickly access the PROG button (as you will have 15 seconds to confirm the threshold
selection).
- Position the curtain outside the limit switch positions.
- Simultaneously press the keys ▲ and ▼ on the veoHz transmitter for 5 seconds —> The motor responds with a "short rotation".
To increase the range, press ▲.
To decrease the range, press ▼.
The motor performs a "short rotation" corresponding to the selected threshold:
- Threshold 1: a rotation of 0.5 s.
- Threshold 2: two rotations of 0.5 s.
- Threshold 3: three rotations of 0.5 s.
- Threshold 4: four rotations of 0.5 s.
1 s.

15- USE AND MAINTENANCE

If the power supply is disconnected for
over 30 seconds, the next radio command
authorised will only be to raise the
curtain to the upper stop points (resetting).
The motor forces the stop points before
"decompressing".
- Instructions for use: refer to the command point manuals and the clutch system manual.
- The motor does not require any maintenance operations. Change the batteries of your command points after 2 years or before that, depending
on how frequently it is used.
16- TROUBLESHOOTING
Observation
The motorised product
is not working
The product does not work
properly
The down command is
ignored
Transmitter LED flashing
very fast or jerky movement
of the product (need to restart
every 3 sec.)
I cannot pair
my mobile transmitter
EN
7/9
The EN12453:2001 standard §5.1.1.4 stipulates that the person operating the door
must always have a direct view of the door, be close to the door when the apron is
moving and not remain in a dangerous position.
By default, the veoHz mobile transmitters have a very short radio range (setting on
threshold 2).
It is the responsibility of the installer to ensure that the defined radio range guaran-
tees a visual command.
After selecting your threshold, confirm the setting within 15 seconds by pressing
"Prog" for 1 second
—> The motor confirms the setting by a "short rotation".
Ensure that the new range ensures an exclusively visual command.
This new radio range is valid for all mobile transmitters that will be programmed later.
When the transmitter exits its defined range, its orders are ignored.
Possible causes
The motor is thermally protected
The motor is disengaged
Out-of-range command point
Command point at range limit
The motor suffered a power failure > 30s or a
disengagement during a failure < 30s
Low battery
Command point not compatible with veoHz
No more channels available (12 max)
Out-of-range command point
Control via
the radio command
Solutions
Wait for the motor to cool down. If the motorised product still
does not work, use the clutch device and contact a motor and
building automation professional.
Re-engage the motor by re-screwing the clutch handle
Get closer to the motor
Get closer to the motor
Raise the curtain up to the upper stop points; the product will
then make a short downward movement.
Replace the battery, otherwise the curtain cannot be moved.
Get a veoHz command point
Delete an existing transmitter
Get closer to the motor
Manual operation
2
using the clutch
1
handle provided