Electrolux EXO18HEIWE Manuel D'installation page 18

18 www.electrolux.com
panel hooks, until the thickness of
the sponge between the body and
the panel's outlet has been reduced
to about 4~6mm. The edge of the
panel should contact with the ceiling
well. (Refer to Fig.20) Malfunction
described in Fig.21 can be caused by
inappropriate tightness the screw. If
the gap between the panel and ceiling
still exists after fastening the screws,
the height of the indoor unit should
be modied again. You can modify the
height of the indoor unit through the
openings on the panel's four corners,
if the lift of the indoor unit and the
drainpipe is not inuenced.
Fig.20
Ceiling Panel foam2
Panel foam
Fig.21
Ceiling
Leakage
Dew
CAUTION!
Screws must be tightly fasten.
Body
Inlet air
Outlet air Air plate
Fig.22
Hexagon nut
Horizontal
adjust ment
Ceiling
Hang the air-in grid to the panel, then
connect the lead terminator of the swing
motor and that of the control box with
corresponding terminators on the body
respectively.
Relocate the air-in grid in the procedure of
Panel sealing
reversed order, install the air-in grid.
foam
3.6 The installation of ventilation
Panel
1.
Panel
foam1
2.
Fig.23
motor and ventilation pipe (if
necessary).
Using a tool to knock off the
prepunching hole. (Refer to Fig.23)
Four screw hole reserved for
installation. (Refer to Fig.23 )
Four screw hole
pre-punching hole