Mark TA209 Livret Technique page 13

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

In case the Display of the control unit is off, make sure that the dip switch is
!
set to position "1" and not position "ON". The dip switch is present on the
main e-board inside the ColdStream unit.
6.2.1.1 Controller descriptions
Keeping pressed more than 1"sec., switches the cooling unit on or off.
Pressed once during setting On/Off periods, exits the menu.
Pressed once during modifying default parameters, exits the menu.
Keeping pressed more than 3"sec., if control unit is locked, makes it tempo-
rary unlocked.
In the OFF position, the Display shows:" oFF ". The panel is always powered
on.
Pressed once, displays the current fan speed (F1-F2-F3-FA).
Pressed once, gets into program selection or into On/Off periods setting.
Pressed once during On/Off periods setting, it has Enter function.
Keeping pressed more than 1"sec., selects operating mode: Cooling ON (ma-
nual), Cooling/Ventilation AUTO (automatic), Ventilation ON (manual).
If time is displaying, sets the current day.
Pressed once during On/Off periods setting, changes days.
Pressed till the display shows "time", it shows the current time setted.
If time is displaying, sets the current hour.
Pressed once during On/Off periods setting, changes hours.
Pressed once during modifying default parameters, increases the value.
Pressed once after pressing FAN command, increases fan speed and/or disa-
bles automatic fan speed.
Keeping pressed more than 2"sec. togheter with M command, changes the
default parameters.
If time is displaying, sets the current minutes.
Pressed once during On/Off periods setting, changes minutes.
Pressed once during modifying default parameters, decreases the value.
Pressed once after pressing FAN command, decreases fan speed and/or disa-
bles automatic fan speed.
Keeping pressed more than 2"sec. togheter with H command, changes de-
fault parameters.
Pressed once, shows the temperature detected.
Keeping pressed more than 5"sec., permits to set the temperature requested
(set-point).
Pressed once, shows the humidity detected.
Keeping pressed more than 5"sec., permits to set the humidity requested
(set-point).
EN
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Tc209

Table des Matières