Remote Control Unit; Inserting The Batteries; Using The Remote Control Unit - Denon DRA-F100 Mode D'emploi

6

REMOTE CONTROL UNIT

The DRA-F100 comes with a system remote control unit (RC-829).
NOTES:
• Use R6P (AA) batteries in this remote control unit.
• Replace the batteries with new ones approximately
once each year, though this depends on how
frequently the remote control unit is used.
• Replace the batteries with new ones earlier if the
remote control unit does not operate even from a
short distance.
• Insert the batteries in the proper + and – direction,
following the marks in the battery compartment.
• Remove the batteries when not using the remote
control unit for extended periods of time.
• To avoid damage and leakage:
• Do not use a new battery with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, take apart, heat or dispose of
batteries in flames.
• If the batteries should leak, carefully wipe the fluid
out of the battery compartment, then insert new
batteries.
• The remote control unit may not operate if the remote
sensor is exposed to direct sunlight or the strong light
from a lighting fixture, or if there is an obstacle
between the remote control unit and the remote
sensor.
• Do not press buttons on the remote control unit and on
the set at the same time. Doing so could result in
malfunction.
7m
30°
30°
All manuals and user guides at all-guides.com

Inserting the batteries

q Open the battery compartment cover on the back of the
remote control unit.
w Insert the two R6P (AA) batteries, following the + and –
marks in the battery compartment.
e Close the cover of the battery compartment.

Using the Remote Control Unit

Cautions on Use
• If the remote control unit is pointed away from the
remote sensor during continuous operations (such as
when turning the volume up or down), the operation
will stop. If this happens, point the remote control unit
at the remote sensor and press the button again.
• The remote sensor is located on the
receiver. Point the remote control unit at
the remote sensor as shown on the
B
diagram when operating it.
TIME
TUN ED R
STER
EO
AUT O
MHz
CH
The remote control unit will operate from a
B
direct distance of approximately 7 meters,
but this distance will be shortened if
obstacles are present or if operated at an
angle.
(The remote control unit will operate at an
angle of up to 30° in either direction.)