X-lite X-551 Sécurité Et Instructions D'utilisation page 14

INSTRUCTIONS FOR USE
• PEAK
Warning!!!
When riding on the road, the peak has to be adjusted to the highest position
(see Position 1 in Fig. 1).
1 ADJUSTMENT
1.1 Release the upper latch A and side latches B, on both sides, unscrewing them
in anticlockwise direction, as shown in Fig. 1.
1.2 Rotate the height of the peak to find the desired position, which is the highest
one when riding on the road (see Position 1 in Fig. 1).
1.3 Lock the peak in the position required by tightening latch A and side latches B
of both sides in a clockwise direction (Fig. 2).
2 DISASSEMBLY
Completely unscrew latch A and side latches B on both sides in an anticlockwise
direction - as shown in Fig. 1 - to completely remove the peak from the helmet shell.
3 ASSEMBLY
3.1 Place the peak on the shell making sure that latch A and side latches B are
inserted in the corresponding slots.
3.2 Lock latches B on both sides by tightening them in a clockwise direction, until
they return to their original position (Fig. 2).
3.3 Adjust the peak as described in section 1.
Warning!!!
- To remove the visor, the peak has to be removed first!
- Every time you wish to use the helmet without peak (see Fig. 17), insert the
stoppers as shown in Fig. 3.
• SCRATCH RESISTANT RACING VISOR: CONVEX COATED
WITH UNIFORM THICKNESS
1 DISASSEMBLY (FIG. 4)
1.1 Open the visor completely.
1.2 Press and hold the visor release button (A) down and slide the visor forward until
it clicks.
1.3 Free the visor fastenings (B1 and B2) from their housing.
1.4 Repeat the same steps on the other side of the helmet.
2 ASSEMBLY (FIG. 5)
2.1 Set the visor in open position by placing the visor fastenings (B1 and B2) in line
with the housings in the visor mechanism.
14
®
VISOR