5. Level : Parameter Settings For The Heating Engineer - geminox QAA 73.110 Notice Technique

4.2 - 5. Level : Parameter settings for the heating engineer

Access the settings list (with the exclusion of some)
of the control unit LMU via the sensor QAA73 and
first level settings.
Buttons
Press on the both line selection buttons
beginning with the button
- This will take you to the first programming mode "LMU" (4. level)
Successive
display:
P R O G
1
et
Press both line selection buttons for at least 3 seconds.
- This will take you to the second programming mode "LMU" (5. level)
Successive
display:
2
P R O G
Press the line selection buttons to select the required line.(rep. b).
- All possible lines are indicated in § 2 - section IV - Parameter list
3
P R O G
Press the plus or minus button to enter the required value (rep. c). The setting will
be stored as soon as you leave the programming mode or change to another line.
4
- The parameter list containing all possible settings is indicated in § 2 -
By pressing the Info button, you leave the programming mode "heating engineer"
5
b)
section IV - Parameter list
Explanation
and setting buttons
.
- 9 -
OPERATING LEVELS
Line
c)
. . .
Permanent
display