Level : Parameter Settings For The Oem - geminox QAA 73.110 Notice Technique

3 - 3. LEVEL : PARAMETER SETTINGS FOR THE OEM

Room sensor-specific settings and protective func-
tions for the boiler manufacturer.
Buttons
Press one of the 2 line selection buttons.
- This will take you to the programming mode "End-user". (1. level)
Display :
1
P R O G
Press both line selection buttons for at least 9 seconds.
- A special display will appear (entering the OEM code : for the manufacturer)
Display :
2
P R O G
Press buttons "+ or -" and "Prog" to enter the required combination of the access
code.
- Correct combination : you reach the programming mode "OEM"
Display :
3
et
- Wrong combination : the display will change to the "Parameter settings for the
P R O G
Display :
Press the line selection buttons to select the required line.(rep. b).
- All possible lines are indicated in § 1.3 - section IV - Parameter list
4
P R O G
Press the plus or minus button to enter the required value (rep. c). The setting will
be stored as soon as you leave the programming mode or change to another line.
5
- The parameter list containing all possible settings is indicated in § 1.3 -
By pressing the Info button, you leave the programming mode "OEM"
6
heating engineer " line 51.
section IV - Parameter list
Explanation
- 7 -
OPERATING LEVELS
Line
. . .
Permanent
display