Assembly And Operation; Intended Use - Worx Sonicrafter WX678 Notice Originale

Avoid danger of injury from the
sharp edges of the accessories.
Accessories can become very hot
while working, presenting danger
of burns!
Make sure the battery is
removed prior to changing
accessories.
Wear protective gloves
High oscillation frequency.
Low oscillation frequency.
LED light is a battery capacity
=
8
indicator and will flash when power
- - -
- - -
gets low .
Waste electrical products should
not be disposed of with household
waste. Please recycle where fa-
cilities exist. Check with your Local
Authority or retailer for recycling
advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE:

The power tool is intended for sawing and
remodelling wooden materials, plastic, plaster,
non-ferrous metals and fasteners (e.g. nails and
clamps) as well as for working on soft wall tiles and
for dry grinding of small surfaces. It is especially
suitable for working close to edges and for flush
cutting.
Oscillating Tool

ASSEMBLY AND OPERATION

Action
Mounting accessories
Mounting the sanding sheet
Mounting the suction device
(not supplied)
Operating the on/off switch
Using the variable speed dial
Remove or install battery pack
LED Light
The Variable Speed Dial can be used to set the
optimum oscillating frequency according to the
accessories used and the respective application.
Oscillation
frequency
High oscillation
frequency:
Low oscillation
frequency:
DISPOSAL OF AN
EXHAUSTED BATTERY PACK
To preserve natural resources, please recycle
or dispose of the battery pack properly. This
battery pack contains Lithium batteries. Consult
your local waste authority for information regarding
available recycling and/or disposal options. Discharge
your battery pack by operating your drill, then remove
the battery pack from the drill housing and cover the
battery pack connections with heavy-duty adhesive
tape to prevent short circuit and energy discharge.
Do not attempt to open or remove any of the
components.
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and run
it with no load for 2-3 minutes to cool the motor. Avoid
prolonged usage at very low speeds. Always keep the
blade sharp.
Always ensure the workpiece is firmly held or clamped
to prevent movement.
Any movement of the material may affect the quality
of the cutting or sanding finish.
Start your tool before working and turn it off only after
you stop working.
Figure
See Fig. A-C
See Fig. D
See Fig. E1-E5
See Fig. F
See Fig. G
See Fig. H
See Fig. I
Application
Sanding, Sawing, Rasping
and Polishing Stone and
Metal.
Scraping, Polishing
Varnishes.
EN