Table des Matières
Publicité
Installation and Operation 20/40/60 Minute Timer: 99-DET01
Operating your Lifebreath 20/40/60 Minute Fan Timer
Press and release the Select Button to activate a 20, 40 or 60 minute high
speed override cycle. The Light will illuminate and the unit will run on
high speed ventilation for the selected time. The Light will dim after 10
sec. for run time. The Light will flash during the last 5 min. of the cycle.
The timer connected to the unit will illuminate for the duration of the
override when the Select Button is pressed.
Lockout Mode
Lockout Mode is useful if you wish to disable the timers.
The timer can be set to lockout mode by pressing and holding the Select
Button for five seconds. After 5 sec., the Light will flash; release the Se-
lect Button. The timer is now in lockout mode. If the Select Button is
pressed during lockout mode the Light will momentarily illuminate but no
override will be initiated.
If lockout mode is initiated when the timer is activated, the timer will
continue its timed sequence but will not allow any further overrides to be
initiated. Lockout mode can be unlocked by pressing and holding the Select
Button for 5 sec. After 5 sec. the Light will stop flashing. Release the Select
Button and the timer will now operate normally.
Optional Plug Installation
The plugs are located in the ERV manual bag. The plugs will be installed into the 2 holes
located in the bottom tray of the ERV. They must be inserted from the inside of the unit to
ensure the holes are fully sealed, see detail below.
Foam Tray
Caution
A drain is required. However in climates where the outdoor temperature remains above -25°C (-13°F)
combined with an indoor humidity less than 30%, the use of a drain is optional.
Core
Plug
Pre-punch hole
Select Button
initiates high
speed ventilation
for 20, 40 0r 60 min.
Yellow #4
Plug
Pre-punch hole
Status
Yellow
Lights
Red
Green
Red #3
Green #5
Foam Tray
19
Publicité
Table des Matières
