Publicité
Built-in Phono Stage
The built-in phono stage is a high specification pre-amplifier. It is designed
to amplify the signal from a moving magnet cartridge to a suitable level
for all line level inputs of an appropriate system or audio amplifier. This
allows simple connection to a wide variety of products using either the
standard twin phono to phono lead (supplied) or phono to 3.5 mm plug (not
supplied).
Note: A 3.5 mm to phono lead must only be plugged into an appropriate
input. DO NOT CONNECT TO A HEADPHONE OUTPUT SOCKET (as found on a
mobile device or similar), as this could damage both the device and player.
Output Connections
Connect the output sockets of the built-in phono stage to a suitable 'line
level' input on your amplifier using the appropriate phono leads.
IMPORTANT: Many amplifiers have a built-in phono stage. Never connect
the P1 Plus to an integrated phono stage. These are usually marked 'Phono'
or 'Disk' input.
Output Connections
Note: Some amplifiers and all in one systems offer adjustable gain settings.
If this option is available, we recommend that the connection used for
the turntable is set to the lowest gain setting to avoid any unnecessary
background noise.
Note: When switching the P1 Plus on or off, a noise may be heard through
the speakers. This is the phono stage powering up momentarily after the
turntable. This is perfectly normal.
Positioning
As with any turntable, take care when positioning. Always place it on a firm
level surface. Never place the turntable on the same surface as desktop
or bookshelf loudspeakers as the energy created by the loudspeakers
can distort the music and affect performance. To optimise performance,
the turntable should be mounted on a hi-fi rack or the dedicated Rega
wallbracket.
Power Connection
Plug in the Rega PS1 350 mA power supply in to the wall socket. Set-up is
now complete. Simply switch on, sit back and enjoy!
2
Warning
Only use the supplied mains adaptors with this product.
PS1 (UK)
Input 230 V AC 50 Hz 0.07 A
Output 24 V AC 350 mA AC
PS1 (EU - Euro 2 pin)
Input 230 V AC 50 Hz
Output 24 V AC 350 mA AC
PS1 (Australian)
Input 240 V AC 50 Hz 0.07 A
Output 24 V AC 350 mA AC
PS1 (UL - American)
Input 115 V AC 60 Hz
Output 24 V AC 350 mA AC
Service
Power Connection
With the unit disconnected from the mains, only clean with a micro fibre
cloth, (lightly damp if necessary). Do not remove any coverings; there are no
user serviceable parts inside. If the unit performs erratically or emits smoke
or odour, disconnect from the power supply and take it to a qualified service
technician.
Warranty
All Rega products are covered by a lifetime warranty against manufacture
defects. This warranty does not cover wear and tear. Any unauthorised
modifications or failure to follow the Rega recommended guidelines may
invalidate the warranty. If returning goods for inspection to your retailer, the
original packaging must be used to preserve the warranty. Damage caused
during transport due to incorrect packaging may invalidate your warranty.
Replacement packaging is available from any Rega retailer. Your statutory
rights are not affected.
Publicité
