How To Detach And Attach The Holder And Neck Strap; If You Think There Is A Failure - Toa WT-5100 Manuel D'instructions

8. HOW TO DETACH AND ATTACH THE HOLDER AND NECK STRAP

8.1. Holder
Raise the holder's tab to detach.
To attach, push the holder till it fits onto the unit
with a click.
1

9. IF YOU THINK THERE IS A FAILURE

Symptom
Power is not switched on.
Receives no radio signal even
when distance to transmitter
is short.
Operation/battery indicator is
flashing slowly.
Receives no radio signal even
when distance to transmitter
is short.
Operation/battery indicator
remains steadily on.
Operation/battery indicator
f l a s h e s r e d a n d g r e e n
alternately.
6
2
Cause
Battery is exhausted.
Incorrect battery polarity
connection.
Channel selector switch is not
set to the same channel as
transmitter.
Earphone plug is not fully
inserted.
Channel selector switch is set
to the invalid channel.
8.2. Neck Strap
When attaching the neck strap, remove the
holder, then fit the strap as shown in the figure.
Neck strap
Holder
(back side)
Replace with new battery.
Remove and reinsert battery.
Set Channel selector switch
t o t h e s a m e c h a n n e l a s
transmitter.
Fully insert earphone plug.
Set Channel selector switch
to the correct channel.
Remedy