General Description - Toa WT-5100 Manuel D'instructions

• Stop charging, if the batteries are not fully
charged within 3 hours. Failure to do so may
cause the batteries to fire, explode, leak, or
heat.
• Never short-circuit the charging terminals on
the bottom of the unit with metal objects.
Doing so could result in electric shocks or
burns.
• To prevent possible hearing damage,
do not listen at high volume levels for
long periods.
CAUTION
When the Unit is in Use
• When the unit is not in use for 10 days or
more, be sure to take the battery out of the
unit because battery leakage may cause
p e r s o n a l i n j u r y o r c o n t a m i n a t i o n o f
environment.
• Make sure to observe the following handling
precautions so that a fire or personal injury
does not result from leakage or explosion of
the battery.
· Do not short, disassemble, heat nor put the
battery into a fire.
· Never charge batteries of the type which are
not rechargeable.
· Do not solder a battery directly.
· Be sure to use the specified type of battery.
· Note correct polarity (positive and negative
orientation) when inserting a battery in the
unit.
· Avoid locations exposed to the direct
sunlight, high temperature and high humidity
when storing batteries.

2. GENERAL DESCRIPTION

TOA's WT-5100 is a Portable Receiver designed to receive UHF band radio signals.
An optional earphone is required.
2
Do not place the dry cell battery into charger.
Placing non-rechargeable batteries in the
charger may cause the battery to crack
resulting in a fire and/or harm to the body.
W h e n r e c h a r g i n g , p l e a s e o n l y u s e t h e
BC-5000-2, BC-5000-6, or BC-5000-12 Battery
Charger and WB-2000 Battery.
Do not use other battery types.
When the battery becomes inflated or leaks,
discontinue use and replace with new one
immediately.
If there's any burning and/or peculiar smell
while charging the battery, please switch off the
power immediately.
C A U T I O N T O U S E R : C h a n g e s o r
modifications not expressly approved by the
party responsible for compliance could void
the user's authority to operate the equipment.
IMPORTANT NOTE: To comply with the FCC
RF exposure compliance requirements, no
change to the antenna or the device is
permitted. Any change to the antenna or the
device could result in the device exceeding
the RF exposure requirements and void
user's authority to operate the device.
License requirement
This device complies with Part 15 of the FCC
Rules.
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions;
(1) T h i s d e v i c e m a y n o t c a u s e h a r m f u l
interference, and (2) this device must accept
a n y i n t e r f e r e n c e r e c e i v e d , i n c l u d i n g
i n t e r f e r e n c e t h a t m a y c a u s e u n d e s i r e d
operation.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.