Safety Information; Safety In Operation; Set-Up Location - Medion LIFE P13041 Mode D'emploi

Safety information

Safety in operation

 Do not allow children to play with electrical devices without supervision. Children can not always
recognise possible dangers correctly.
 Keep the packaging materials, such as plastic film, away from children. The danger of suffocation
could arise in the case of misuse.
 Never open the casing of the TFT monitor (electric shock, short circuit and the danger of fire)!
 Do not introduce any objects into the inside of the TFT monitor through the slots and openings
(electric shock, short circuit and the danger of fire)!
 The slits and opening of the TFT monitor serve ventilation. Do not cover these openings (overheating,
danger of fire).
 Do not exert any pressure on the display unit. There will be the danger of the monitor breaking.
 Attention! There will be the danger of injury if the display unit has been broken. Pack up the broken parts
with protective gloves and send them to your service centre for specialist recycling. Then wash your
hands with soap, because it cannot be excluded that chemicals can escape.
 Do not touch the display unit with your fingers or with sharp objects, in order to avoid damage.
Contact Customer Service if:
 The mains cable has been contaminated or damaged
 Liquid has penetrated the monitor
 The TFT monitor is not functioning correctly
 The TFT monitor has been dropped or the casing is damaged

Set-up location

 New devices can emit a typical, unavoidable but completely harmless smell, which reduces increasingly
in the course of time, in the initial hours of operation. We recommend that you ventilate the room
regularly, in order to counter the formation of the smell. We have taken care that the applicable limits are
clearly fallen below during the development of this product.
 Keep your TFT monitor and all the connected devices away from moisture and avoid dust, heat and
direct solar radiation. Failure to comply with this information can lead to faults or damage to the TFT
monitor.
 Do not operate your device in the open air, because external influences, such as rain, snow, etc. could
damage the device.
 Do not subject the device to drops of water or spray and do not put any containers filled with liquid
(vases or similar) on the device. Liquids penetrating can impair the electrical safety of the device.
 Do not put any open sources of fire (candles or similar) on the device.
 Pay attention to sufficiently large clearances in the wall unit. Maintain a minimum clearance of 10
cm around the device for sufficient ventilation.
 Place and operate all components on a stable, level and vibration-free base, in order to avoid the TFT
monitor falling.
 Avoid fading effects, mirror effects and too strong contrasts between light and dark, to save
your eyes and to guarantee comfortable workstation ergonomics.
 Take regular breaks when working at your TFT monitor, to prevent tension and tiredness.
Safety information
DE
EN
FR
ES
IT
NL
DK
3