Cleaning, Maintenance And Ordering Of Spare Parts; Replacing The Power Cable - Bavaria BVC 1815 S Instructions D'origine

Blowing
Connect the suction hose (10) to the blow con-
nector (9)
One or more of the elements which make up the
3-part suction tube (11) can be attached to the
suction hose (10) to extend it.
5.4 Suction nozzles
The combination nozzle (12) with attachments is
for vacuuming solids and liquids over medium to
large areas. The crevice nozzle (16) is specially
designed for cleaning cervices and edges.
6. Operation
Important!
Switch off the equipment if liquid or foam is
emitted with the exhaust air when wet vacuum
cleaning.
6.1 On/Off switch (Fig. 1)
Switch position 0:
Switch position I:
6.2 Dry vacuuming
Use the dirt bag (14) and the additional fi lter for
dry vacuuming (see point 5.2).
Always ensure that the fi lters are perfectly secure.
6.3 Wet vacuuming
For wet-vacuuming, use the foam fi lter (15) (see
point 5.2).
Check that the fi lter is securely fi tted at all times.
Important.
When wet vacuuming, the fl oating safety switch
(5) turns off the wet and dry vacuum cleaner auto-
matically when the maximum level is reached.
Important!
The wet and dry vacuum cleaner is not suitable
for the vacuuming of combustible liquids.
For wet vacuuming, use only the supplied foam
fi lter.
6.4 Blowing
Connect the suction hose (10) to the blow con-
nector (9) on the wet and dry vacuum cleaner.
Anl_BVC_1815_S_SPK7.indb 14 Anl_BVC_1815_S_SPK7.indb 14
GB
7. Cleaning, maintenance and
ordering of spare parts
Important!
Always pull out the mains power plug before star-
ting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible.
•
We recommend that you clean the equipment
immediately after you use it.
7.2 Cleaning the appliance head (3)
Clean the appliance regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the plas-
tic parts in the appliance.
7.3 Cleaning the container (7)
The container can be cleaned with a damp cloth
and some soft soap or under running water, de-
Off
pending on the amount of dirt.
On
7.4 Cleaning the foam fi lter (15)
Clean the foam fi lter (15) with a little soft soap un-
der running water and allow it to air-dry.
7.5 Servicing
At regular intervals and before each use, check
that the fi lters in the wet and dry vacuum cleaner
are securely fi tted.
7.6. Ordering spare parts
Please provide the following information on all
orders for spare parts:
•
Model/type of the equipment
•
Article number of the equipment
•
ID number of the equipment
•
Part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info

8. Replacing the power cable

If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
- 14 -
06.02.2017 10:55:14 06.02.2017 10:55:14