Bosch SHE7PT5 UC Série Guide D'utilisation page 26

Problem
Dishes are 1. Spray arm movement obstructed
not getting 2. Spray arm nozzles clogged
clean 3. Improper use of detergents
enough 4. Filters could be clogged
5. Dishes are nested or loaded too
close together
6. Selected wash cycle is not suitable
for food soil conditions
Streaks on 1. Incorrect rinse aid setting
glassware
or residue
on the
dishes
Dishes are 1. Rinse aid dispenser is empty
not getting 2. Improper loading of dishes
dry enough Note: Plastic or Teflon do not typically dry
as well as other items due to their inher-
ent properties
Odor 1. Food debris is present at the bot-
tom of the dishwasher
Note: Water
testing is done
2. Food particles are present near
in the factory.
the door seal
Occasionally
3. Residual water is present at the bot-
water may still
tom of the dishwasher
appear in
4. Drain hose is obstructed
dishwasher at
purchase
which may
create an
odor.
23
Cause Action
1. Ensure that spray arm movement is
not blocked by hand rotating spray arms
before starting cycle
2. Remove the spray arms and clean
according to the "Care and Mainte-
nance" section of the manual
3. Increase or decrease detergent
depending on the water hardness
(refer to Table 1)
4. Clean the filters according to the
"Care and Maintenance" section of the
manual
5. Rearrange load such that water
spray can reach all items in the dish-
washer - see "Loading the Dishwasher"
section of the manual
6. Refer to "Wash Cycle Information" sec-
tion of the manual
1. Depending on the hardness of
water, adjust the rinse agent dis-
penser. Refer to "Adding Detergent
and Rinse Aid" section in the manual
1. Add rinse aid - the use of rinse agent
improves drying
2. Rearrange load to ensure items are
not nesting (see "Loading the Dish-
washer" section of the manual)
Note: Select models offer an extra heat-
ing option to improve drying perfor-
mance.
1. Remove the filters and clean accord-
ing to the "Care and Maintenance" sec-
tion of the manual
2. Refer to "Care and Maintenance" sec-
tion of the manual
3. Ensure the unit has completely
drained from the last cycle
4. Remove any obstructions from the
drain hose by calling qualified personnel.
Note: If odor still persists, run the Nor-
mal/Regular cycle until it flushes and
interrupt the cycle and place an 8oz. cup
of distilled white vinegar solution on the
upper rack and then finish the cycle.