Bosch SHE7PT5 UC Série Guide D'utilisation page 21

Interrupt a cycle
1 Press the [On/Off] button to turn the unit off.
2 To resume the cycle, press the [On/Off] button again.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1 Press the [On/Off] button. Select a cycle.
2 Press the [Delay] button until the displayed time corresponds with
your requirements and press [Start] to activate delay start.
h:01 = 1 hour delay h:24 = 24 hour delay
To cancel delay start:
1 Press the [Delay] button until "h:00" is indicated on the digital display.
2 Press [Start] to save setting.
Cycle Completion Signal
1 Open the door and press the [On/Off] button.
2 Hold down the "A" button (see page 17) and press [Start] until the
display indicates "d:00". Release both buttons.
3 Press the "A" button until the display shows "b:02".
4 Press the "C" button to increase or decrease the tone "b:00" = OFF and
"b:03" = LOUDEST and press [Start] to save setting and close the door.
Intensive Drying
The final rinse uses a higher temperature which improves the drying
results. The running time may increase slightly.
To turn intensive drying on:
1 Press the [On/Off] button.
2 Hold down the "A" button (see page 17) and press [Start] until the
display indicates "d:00". Release both buttons.
3 Press the "A" button until the display shows "d:00".
4 Press the "C" button to turn intensive drying on or off. "d:01" = ON
and "d:00" = OFF and press [Start] to save setting.
Auto Power Off/Interior Light (model dependent)
To save energy, the dishwasher is turned off 1 minute after the wash
cycle ends (Auto Power Off). The Interior Light is a white light which illu-
minates the interior when the dishwasher is open. These functions can
be adjusted from P:00 to P:02.
To change the setting:
1 Press the [On/Off] button.
2 Hold down the "A" button (see page 17) and press [Start] until the
display indicates "d:0x" (x can be any number). Release both buttons.
3 Press the "A" button until the display indicates "P:0x".
4 Press the "C" button until the display corresponds with your require-
ments.
P:00 = dishwasher does not turn off automatically - Interior Light always on
P:01 = dishwasher turns off automatically after 1 min - Interior Light always off
P:02 = dishwasher turns off automatically after 120 mins (2 hrs) - Interior Light always off
5
Press [Start] to save the setting
.
18