Product Closure; Maintenance; Replacement Of The Cover Gasket - Videotec MAXIMUS MBX Manuel D'instructions

5.7 Product closure

During product opening and closing
operations, be careful not to damage the
flameproof joint.
Before closing the cover, check the O-ring
gasket. If the sealing is damaged replace it
with the one supplied.
Verify that there is no dirt or debris.
Lubricate the threads with grease compliant with IEC/
EN60079-14 to facilitate screwing the cover on.
Screw the cover and ensure there is not space
between the cover and the body of the box.
Fastening the safety grub screw is mandatory to
complete product closure and prevent the unwanted
unscrewing.
Fig. 6
14

6 Maintenance

When contacting VIDEOTEC for assistance please
provide the serial number and the identification code
of the model.
6.1 Replacement of the cover
gasket
In the event of o-ring gasket deterioration replace
it using the gasket supplied. Use only VIDEOTEC
original spare parts.
Replace the gasket being careful to insert it correctly
into its specific position.
Fig. 7
MNVCMBX_2222_EN