Blower Replacement - Napoleon GDS26N-1 Instructions D'installation Et D'opération

7.0 BLOWER REPLACEMENT

TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.
USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GAS
COMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILL
ENSURE THAT THE FAN'S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THE
APPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWER
THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHEN
INSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKING
ELECTRICAL INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must be connected and
grounded in accordance with local codes. In the absence of local codes, use the current CSA C22.1 Canadian
Electrical Code in Canada or the current ANSI/NFPA 70 National Electrical Code in the United States.
1. Disconnect the gas and power supply.
2. Remove the 4 screws securing the blower mounting plate to the appliance.
3. Disconnect the two flag connectors and the grounding wire.
4. Remove the 3 screws securing the blower to the mounting plate.
5. Install the new blower by securing it to the mounting plate using the 3 screws removed in step 4.
6. Reconnect the two flag connectors and the grounding wire to the new blower.
7. Resecure the blower mounting plate to the appliance using the 4 screws removed in step 2.
8. Reconnect the gas and power power supply.
BLOWER
!
RISK OF FIRE AND ELECTRICAL SHOCK.
VOID THE WARRANTY AND CERTIFICATION.
CORD BENEATH THE APPLIANCE.
CONTACT WITH MOVING OR HOT OBJECTS.
WIRING DIAGRAM
BLACK
WIRE
HARNESS
GREEN
TO
(GROUND)
IPI
CONTROL
WARNING
35
51.5
GROUND
SCREW
BLOWER
ASSEMBLY
W415-2183 / B / 02.10.17
EN