Installation - Dometic Ultra Breeze 1400 Manuel D'installation Et D'utilisation

4 INSTALLATION

4.1 Installing the Ultra Breeze Vent Cover
1
Tab Holes
Tabs
Vent Cover
➤ Locate the plastic cable ties that secure the Vent
Cover to the grill. Cut the cable ties and discard.
➤ Install the grill into the Vent Cover using the two
push-in retainers provided. Position the three slots
on the top of the grill onto the three tabs located
on the under side of the Vent Cover. Align the hole
at the bottom side of the grill with the hole on
the side of the Vent Cover and insert the push-
in retainer to secure the Vent Cover. Repeat this
procedure for the opposite side making sure the
top of the grill stays secured at the top.
4.2 Securing the cover
3
Washer
Hairpin
Cotter Pin
Cover
➤ Align the vent cover slots over the clevis pins with
Washer and secure with the hairpin cotter pin.
➤ Rotate the clevis pin and hairpin cotter to the best
locking position.
5
2
Second
Screw
Grill
Push-In Retainer
➤ Remove two #8 x 1" installation screws (second
➤ Apply sealer into and around the holes and install
4
(Front of RV)
Clevis Pin
➤ Use 1/4" drive rivets to plug holes on the side of
from the front and second from the back) from the
base on both (curb and driver) sides of the existing
vent.
the Vent Cover brackets using the supplied
#10 x 1-1/4" Phillips pan head screws.
Holes
Driver Side View
the cover.
Vent Cover
Bracket
EN