Electronic Control Operating Instructions; Operation Panel Of The Air Conditioner; Air Conditioner Features - Airwell MFH Serie Manuel D'utilisation Et D'installation

ELECTRONIC CONTROL OPERATING INSTRUCTIONS

Before you begin, thoroughly familiarize yourself with the control panel and remote controller
and all its functions, then follow the symbol for the functions you desire.
The unit can be controlled by the unit control panel alone or with the remote controller .
NOTE: This manual does not include Remote Controller Operations, see the <<Remote
Controller Instruction>> packed with the unit for details.

OPERATION PANEL OF THE AIR CONDITIONER

7
(Optional)
Fig.3
1 POWER button
Power switch on/off.
2 SLEEP button
Used to initiate the SLEEP operation.
3 FAN/ION button (ION is optional)
Control the fan speed. Press to select the fan
speed in four steps-LOW, MED, HI and AUTO.
The fan speed indicator light illuminates under
different fan settings except AUTO speed. When
select AUTO fan speed, all the fan indicator lights
turn dark.
NOTE: Press this button for 3 seconds to initiate
ION feature.The ion generator is energized and will
help to remove pollen and impur ities from the air, and
trap them in the filter. Press it for 3 seconds again to
stop the ION feature.
4 UP( ) and DOWN( ) button
Used to adjust (increasing/decreasing)
temperature settings(1 C/2 F increments)
in a range of 17 C(62 F) to 30 C(88 F) or
the TIMER setting in a range of 0~24hrs..
NOTE: The control is capable of displaying
temperature in degrees Fahrenheit or degrees
Celsius. To convert from one to the other, press and
hold the Up and Down buttons at the same
time, for 3 seconds.
(Optional)
6 5
+

AIR CONDITIONER FEATURES

9
8
4 4
5 MODE select button
Selects the appropriate operating mode.
Each time you press the button, a mode
is selected in a sequence that goes from
AUTO, COOL, DRY, FAN and HEAT(cooling
only models without). The mode indicator
light illuminates under the different mode
settings.
6 TIMER button
Used to initiate the AUTO ON start time and
AUTO OFF stop time program, in conjuction
with the + & - buttons. The timer on/off
indicator light illuminates under the timer on/
off settings.
7 SWING button
(Applicable to the models with auto swing feature
Used to initiate the Auto swing feature.
When the operation is ON, press the
SWING button can stop the louver at
the desired angle.
8 LED Display
Shows the set temperature in "
"
F" and the Auto-timer settings.
O
Wh ile on DRY and FAN modes, it shows
the room temperature.
3 2
(ION is Optional)
1
C" or
O