Alber e-motion Notice D'utilisation page 8

System range
The e-motion remote control is designed to operate most effectively at ranges up to 10 metres. Walls and even steel
constructions can be penetrated by the system. The maximum range is only attained, however, if there is a line of
sight to the receiver and if there is no high frequency interference.
Potential causes of reduced range:
- Buildings of all kinds and vegetation influence the range.
- The distance of the aerial from the body and to other conducting surfaces or objects (including the ground) strongly
influences the radiation characteristics and therefore the effective range.
2
- The "background noise" in non-rural areas can be quite high, which reduces the signal to noise ratio and so also the
range. It can also not be ruled out that devices with a similar working frequency are operating in the
neighbourhood and so appear to make the receiver less sensitive.
- If the receiver is near badly screened devices that produce radiation (e.g. PC's), marked reductions in range or an
apparent complete failure of the receiver to work may occur.
Proper usage
The e-motion remote control transmits an individually coded signal by radio waves to the associated receiver in the e-motion
wheel. The function that then takes place depends on the receiver and its wiring.
Please remember that wireless communication is always potentially subject to interference!
The e-motion remote control must not be modified or rebuilt and it can be used without being registered and without any fees
being paid.
The e-motion remote control is approved for use in the following countries:
German Federal Republic, Austria, Denmark, Finland, France, the Netherlands, Norway, Sweden, Great Britain and Switzerland.