AEG 69503G-M Notice D'utilisation page 19

• Make sure that the appliance is not damaged because of transport. Do not connect a
damaged appliance. If it is necessary, speak to the supplier.
• Only use built-in appliances after you assemble the appliance into correct built-in units
and work surfaces that obey the standards.
• Do not install the hob over a domestic appliances if the installation instructions do not
allow it.
• Install the appliance only on a worktop with flat surface.
• Do not change the specifications or modify this product. There is the risk of injury and
damage to the appliance.
• Fully obey the laws, ordinances, directives and standards in force in the country where
you use the appliance (safety regulations, recycling regulations, electrical safety rules
etc.)
• Keep the minimum distances to other appliances and units.
• Install anti-shock protection, for example install the drawers only with a protective panel
directly below the appliance.
• Prevent damage of the cut surfaces of the worktop against moisture with a correct seal-
ant.
• Seal the appliance to the worktop with no space left with a correct sealant.
• Prevent damage to the bottom of the appliance from steam and moisture, e.g. from a
dishwasher or oven.
• Do not install the appliance adjacent to doors and below windows. Hot cookware can be
hit off the hob when you open the doors or windows.
• Before installation, make sure that the local supply conditions (gas type and pressure)
agree with the adjustment of appliance. The adjustment conditions for the appliance are
on the rating plate, which you can find near the gas supply pipe.
• This appliance is not connected to a combustion products evacuation device. It must be
installed and connected in accordance with current installation regulations. Particular
attention must be given to the relevant requirements regarding ventilation.
• The use of a gas cooking appliance cause heat and moisture in the room in which
it is installed. Make sure that the ventilation in the kitchen is good: keep natural
ventilation holes open or install a mechanical ventilation device (mechanical ex-
tractor hood).
• More ventilation (for example opening of a window or increasing the level of me-
chanical ventilation where present) is necessary when you operate the appliance
with intensity for a long time.
• Carefully obey the instructions for electrical connections. There is the risk of injury from
electrical current.
• Disconnect the appliance from the electrical supply, before you do the mainte-
nance work or you clean it.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Install correctly to give anti-shock protection.
• A loose and incorrect mains plug and socket connections can make the terminal become
too hot.
• A qualified electrician must install the clamping connections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains connection cable and replace the damaged mains cable with ap-
plicable cable. Speak to your local Service Force Centre.
Safety information
19