Publicité
Les langues disponibles
Les langues disponibles
Close the open side of the spray bar with the enclosed
end cap.
TIP: The spray bar can either be installed below water level
or just above the surface, depending on whether you wish
to have oxygen-rich surface movement or not.
TIP: If you lay the tubing into warm water for some time
beforehand, they will become soft and possible kinks can
be easily squeezed out.
Attach the intake strainer to
the intake tube and fasten it
onto the interior glass of the
tank with two clips and suc-
tion cups.
Note: When using with an
EHEIM professionel hood,
the intake pipe is simply
clipped into place and you
don't need the suction cups.
Connect the security outlet
pipe and spray bar with a
short piece of tubing and
install in the aquarium with
the clips and suction cups.
Place on the rear or on one
of the sides of the tank,
depending on available di-
mensions.
Guide the hoses from the
filter outwards, through the
opening in the aquarium ca-
binet, and connect the in-
stalled intake pipe and out-
put pipe according to the
respective tubing diameters.
To achieve an even flow, be
sure that the tubing is laid out
smoothly and has no kinks;
if necessary, shorten them.
°
C
Thermofilter
Installation of thermostat
and temperature sensor
Attach
the
temperature
sensor with 2 suction cups
and clips to the aquarium in
such a manner that it is
positioned beneath the surface of the water.
Do not install the temperature sensor near the filter
outflow. The thermostat can be placed on the aquarium
hood or attached with the enclosed velcro tape to either
the aquarium hood or the pump head of the filter. Protect
against splashing water.
Note: If you have an EHEIM professionel aquarium hood,
you can obtain a modular thermostat free of charge by
exchanging it for the original one.
The universal thermostat included with the filter (when new)
must be sent to EHEIM in the enclosed shipping carton for
a free of charge exchange. See note on the "thermostat"
shipping package.
Direct the control cable from
the filter canister to the ther-
mostat and connect the
plug, you should hear it
snap into place.
Do not yet connect the
heater's mains plug.
11
GB
Publicité
