Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.3
PUMP MAINTENANCE, SPARE PARTS AND DECOMMISSIONING
Pumps are designed to operate without maintenance for several years. Spare parts will be available for at least 3
years from the warranty period expiration. This product and its components must be disposed of in an
environmentally friendly manner. Use waste collection services, if this is not possible, contact the nearest IMP Pumps
Service or authorized repairers.
2
SAFETY
These instructions should be studied carefully before installing or operating the pump. They are meant to help you
with installation, use and maintenance and to increase your safety. Installation should only be performed with
regards to local standards and directives. Only qualified personnel should maintain and service these products.
Failure in following these instructions can cause damage to the user or product and can void warranty. Safety
functions are only guaranteed if the pump is installed, used and maintained as described in this manual.
3
TEHNICAL SPECIFICATIONS
3.1
STANDARDS AND PROTECTIONS
Pumps are made in according to the following standards and protections:
Protection class:
IP44
Pump type
NMT(D) MAX (C) 32-120
NMT(D) MAX (C) 40-40
NMT(D) MAX (C) 40-80
NMT(D) MAX (C) 40-120
NMT(D) MAX (C) 40-180
NMT(D) MAX (C) 50-40
NMT(D) MAX (C) 50-80
NMT(D) MAX (C) 50-120
NMT(D) MAX (C) 50-180
NMT(D) MAX (C) 65-40
NMT(D) MAX (C) 65-80
NMT(D) MAX (C) 65-120
NMT(D) MAX (C) 65-180
NMT(D) MAX (C) 80-40
NMT(D) MAX (C) 80-80
NMT(D) MAX (C) 80-120
NMT(D) MAX (C) 80-180
NMT(D) MAX (C) 100-40
NMT(D) MAX (C) 100-80
NMT(D) MAX (C) 100-120
NMT(D) MAX (C) 100-180
Insulation class:
180 (H)
Installation specification
Nominal pressure
Common hydraulics
PN6 and 10
Separate hydraulics
for PN 6 and PN 10
24
Motor protection:
Thermal - built in
Fitting length [mm]
220
220/250
220/250
220/250
220/250
280
280
280
280
340
340
340
340
360
360
360
360
450
450
450
450
Publicité
Chapitres
Table des Matières
Dépannage
