Troubleshooting; Electrical Certifications - baracuda S3 Robotic Manuel Du Propriétaire

TROUBLESHOOTING

ISSUE: The cleaner is not properly adhering to the bottom of the pool.
SOLUTION: Repeat the instructions noted in "Submerging the Cleaner" section of
the manual to release trapped air.
ISSUE: The cleaner will not climb the walls.
SOLUTION: • Ensure the filter element is not full or clogged up.
If it is, simply clean it.
• Although the water seems clear, your pool may contain microscopic
algae (not visible to the naked eye), which are making the sides
slippery and are preventing the cleaner from climbing them. In this
case, super chlorinate the pool and adjust the pH level.
Do not leave the cleaner in the pool during super chlorination.
ISSUE: The cleaner is not moving at all.
SOLUTION: • Check that the power supply's electrical plug is functioning correctly.
Try another electrical product to verify.
• Check that you have started a Perfect or Turbo cleaning cycle.
ISSUE: The cleaner seems to be performing less efficiently.
SOLUTION: • Ensure the surface of the brushes have not become smooth.
We recommend that the brushes are changed every two (2) years,
or sooner if they are worn.
• Ensure the filter element is not full or clogged.
If it is, simply clean it.
• Ensure the floating cable is not excessively coiled or twisted.
For further troubleshooting information, please contact Zodiac Pool Systems, Inc.
at 800-822-7933. In Canada, call 888-647-4004.

ELECTRICAL CERTIFICATIONS

SAFETY STANDARDS:
Baracuda S3 Robotic is listed by
®
ETL as being in compliance with
the relevant requirements of UL
1081 and CSA 60335-2-41.
11
10