Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
AMR SENSORS- Mode d'emploi / User guide version V1.2
3.4. Configuring the AMR SENSORS unit
Your AMR Sensors product is delivered with the following factory settings: WMBUST1 radio mode, sending interval of 10 minutes, and active
On-Off sensors 1 & 2. The combination of switches enables your AMR Sensors unit to be configured. The following parameters may be modified:
•
Transmission interval
•
Inputs activation (sensors 1 and 2)
•
The type of sensor connected (analogue or digital -On-Off-)
Note 1: The Wireless M-Bus radio mode can only be configured using the WMBUS USB configuration key and the dedicated software. The
default radio mode is T1 mode.
Note 2: Activation of the sensors and the type of sensors (analogue or digital -On-Off-) can only be done via the switches.
CONFIGURATION TABLE:
Parameter
Periodicity of radio transmission
Activation of sensors inputs
Type of sensor
NB: Each change in a switch's position is considered by the AMR Sensors unit to be a changeover to Configuration mode. The product therefore
then automatically returns to Standby position.
If you modify the product's configuration, it will then be mandatory to switch (back) to Operations mode by passing a magnet near the activa-
tion system (cf. Chapter 3.6).
3.5. Closing the casing
Once stages 3.2, 3.3 and 3.4 have been carried out, you can close the casing of the AMR Sensors unit.
Procedure:
•
Make sure that the seal is properly positioned on the base
Value
10 seconds
10 minutes
1 hour
12 hours
Sensors 1&2 inactifs
Sensor 1 actif
Sensor 2 actif
Sensor 1&2 actifs
Sensor 1&2 ANA
Sensor 1&2 I/O
Sensor 1 ANA, Sensor 2 I/O
Sensor 1 TOR, Sensor 2 I/O
SW3
SW1
SW2
(Sensor 1)
ON
OFF
OFF
OFF
OFF
ON
ON
ON
OFF
ON
OFF
ON
Seal
SW4
SW5
(Sensor 2)
(Sensor 1)
(Sensor 2)
OFF
OFF
ON
ON
OFF
ON
OFF
ON
Page
SW6
OFF
ON
ON
OFF
32
of 41
Publicité
Table des Matières
