Table des Matières
Publicité
INSTALLATION Continued
Assembly of Broiler
Steel Grate Rods
Each broiler is supplied with (14) 15"/381mm, (-18B),
21"/533mm, (-24B), 26" /660mm, (-30B), or 31"/787mm, (-36B)
long steel rods. These rods are to be installed in the grooves
on the support brackets, which are atop the burners.
Briquettes
For best cooking results, it is recommended that the correct
amount of briquettes are installed in the broiler. Refer to
the table and drawing below for the proper arrangement
of briquettes. When all the briquettes have been placed as
instructed, install the top grate sections.
MODEL
Rows front to rear
Rows left to right
Space briquettes evenly on rods in number of rows and
columns specified for your particular model.
Page 8
-18B -25B -30B -36B
7
7
7
7
7
11
14
17
Sanitary Countertop Seal
When the broiler is installed on a countertop, the National
Sanitation Foundation, (NSF), International recommends
that it be sealed in accordance with NSF standards per the
following instructions:
1. Unit should be located on a non-combustible, level
countertop surface.
2. Thoroughly clean the bottom perimeter of the broiler and
the countertop around the bottom of the broiler.
3. Apply a generous bead of silicone sealant around the
entire outside perimeter of the broiler bottom.
4. The broiler can be secured to the countertop by inserting
the 3/8-inch diameter crating bolts through the counter
from the bottom, (via predrilled 1/2" diameter holes), and
threading them into the nut inserts in the bottom of the
nit.
5. Smooth the silicone sealant with a finger or tool to
provide a cover seal.
Assembly of Optional Stands
1. Fit stand ends together.
2. Secure stand together with (8) 10-24 machine screws,
lock washers and 10-24 hex nuts, (provided). Use only the
front and back pieces.
3. If the stand exceeds a four, (4), foot length, use the
optional cross member. Optional cross member
mounting brackets are secured with ten, (10) each of the
following, (provided): 10-24 machine screws, 1/4-inch
lock washers, and 10-24 hex nuts.
4. Position a square foot insert in the bottom of one of the
legs, and use a light hammer to tap the insert upward
into the leg until it seats at the collar flange.
5. Repeat step 4 for each.
Part # 1382683 (01/08)
Publicité
Table des Matières
