Possible Failure And Its Solution - Lincar Alice 480N Manuel D'instructions

Possible failure and its solution

3.4
DEFECT
Windows fire door and/or
combustion chamber are
dirty of soot.
Not regular draft
Too much dark fumes
from the exhaust
Fumes escape from the
stove
Every intervention has be done from qualify staff !
Lincar S.r.l is not responsible for damages to thing or people due to a wrong installation,
equipment tampering, improper use, bad maintenance or no observation of normative in
force. If considerate appropriate, Lincar S.r.l. reserves the right to make modifications without
notice and in every moment.
Some particulars and accessories illustrated in this handbook are not mass produced item so
its extra costs are to check at contract release.
IT IT IT IT- - - - GB GB- - - - FR
GB GB
CAUSE
− Low draft <10 Pa.
− Wrong regulation.
− Too much combustible
introduced.
− Combustible with high
humidity level.
− Not good quality
combustible.
− Flue / exhaust fumes
unsuitable or dirty.
− Stove is dirty inside.
− Stove light on with
green wood.
− Stove dirty inside.
− The fire/ash door is open
while the fire is burning.
− Draft insufficient.
− Not correct regulation
during ignition operation
− The stove should be
cleaned.
32/64
FR- - - - ES ES mod. 470-480LZ-490LZ-480N-490N
FR FR ES ES
SOLUTION
− Check that the exhaust fumes
tube is not obstructed.
− Modify the flue : increase the
flue's hight, end units not
correct, improve the isolation /
seal
− Read the charter "Regulations".
− Reduce the quantities.
− Employ dried wood.
− Read the chapter "Combustible".
− Require chimney sweep
intervention.
− Clean the stove.
− Light on the stove with dried
wood.
− Call the assistance service.
− Close the doors.
− Call the chimney – sweeper to
check the chimney flue.
− Read the chapter "Regulations"
and "Combustible to employ".
− Clean all the connection tubes
and the chimney.