Length And Angle Adjustment Of The Footrest; Adjusting Seat Height (Rear Wheel Mount); Adjusting Seat Height (Front Wheel Mount); Adjusting The Height Of The Backrest - Drive ROTEC Mode D'emploi

EN
4 5
Never swivel the footrests inwards!
Length and angle adjustment
of the footrest
Length adjustment
(photo 7)
Use the enclosed Allen
wrench to loosen the
screw on the footrest and
adjust the length as desi-
red by shifting up or down.
Retighten the screw!
Angle adjustment
(photo 8)
Use the enclosed Allen
wrench to release the
screw on the footrest until
it can be pulled out of the
toothed wheel inwards.
Now rotate the footrest
into the desired position
and press it back into the
toothed wheel.
Retighten the screw!

Adjusting seat height (rear wheel mount)

The height of the seat at
the rear can be adjusted
in increments. To adjust
it, remove both hand rim
wheels by pressing the re-
lease button (see section
"Attach wheels"). Unscrew
the nut of the wheel mount
and move it into the desi-
red hole.
Replace the nut with the
locking washer and tigh-
ten it (photo 9).
Ensure that the wheel axle is properly tightened!
16
Drive Medical GmbH & Co. KG | As per: 30.06.2020 | Errors and alterations excepted
6

Adjusting seat height (front wheel mount)

The height of the seat can be adjusted in increments and
is correspondingly adjusted in the desired inclination
of the seat surface. To adjust, unscrew the wheel axle
screw and pull it out.
The plugs of the corres-
ponding holes can be ea-
sily exchanged. Now move
the wheel in the desired
position and reinsert the
wheel axle screw and tigh-
ten it (photo 10).
Ensure that the wheel
axle is properly tightened!

Adjusting the height of the backrest

The height of the backrest
can be adjusted in incre-
ments.
Note: When the backrest
is adjusted, the height of
the push handles is also
automatically adjusted.
To adjust the backrest,
remove the left and right
nuts under the guide tube
of the backrest (photo 11).
Pull the screws out. Now adjust the desired height by
pulling or pushing on the respective push handle.
Reinsert the screws, put on the knurled nuts and tighten
them.
Always ensure that both sides are adjusted identically.
Instructions for use ROTEC