Product Features - Black & Decker FLEX PAD1200 Mode D'emploi

Masquer les pouces Voir aussi pour FLEX PAD1200:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNINg:
positive ground or a different voltage.
• The cigarette lighter socket may not be live when the ignition is off and/or the key is removed.
If in doubt, consult your vehicle's owner's manual for information regarding the above.
• Use only as described in this manual. Use only manufacturer's recommended
attachments.
• Do not use the appliance near water. Do not immerse the appliance in water.
WARNINg:
than recommended by the vehicle manufacturer. This product is rated to draw 10 amperes
from a 12V vehicle outlet. Ensure that the electrical system in your vehicle can supply this
product without causing the vehicle fusing to open. This can be determined by making
sure the fuse in the vehicle which protects the outlet is rated higher than 10 amperes.
Information on the vehicle fuse ratings are typically found in the vehicle operator's manual.
If a vehicle fuse opens repeatedly, do not keep on replacing it. The cause of the overload
must be found. On no account should fuses be patched up with tin foil or wire as this may
cause serious damage elsewhere in the electrical circuit or cause fire.
WARNINg:
sometimes there is a possibility of small debris being discharged from the air vents, especially
after cleaning / replacement of the filters as debris inside the unit can be disturbed.
Symbols
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
or DC ..direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
SAve TheSe INSTRUCTIONS

PRODUCT feATUReS

1. On/off power switch
2. Removable handle
3. Locking ring
4. Hose
5. Dust container door
6. Door latch
7. Accessory clip
8. 2-in-1 nozzle accessory
9. Crevice tool
10. Vehicle adaptor
11. Storage recess
12. Cord clip
ASSeMBLy
MOUNTINg ACCeSSORIeS (fIgUReS A - C)
The 2-in-1 nozzle (8) has a brush that can be folded
forward for dusting and upholstery cleaning (figure A).
The crevice tool (9) allows for vacuuming in narrow
and hard-to-reach places.
• To attach an accessory, press the accessory clip
(7) and slide the accessory onto the handle (2).
• To remove an accessory, press the accessory clip and
remove the accessory as shown in figure B.
: Do not operate the appliance with systems which have
Risk of Fire. Do not replace any vehicle fuse with a rating higher
Do not look into the air vents when the unit is switched on, as
3
A ...................amperes
W ..................watts
or AC .......alternating current
n o .................no load speed
.................earthing terminal
.................safety alert symbol
.../min or rpm..revolutions or reciprocation
per minute
7
8
A
2
1
5
6
12
11
9
10
3
4

Publicité

Table des Matières
loading

Table des Matières