Important Safeguards - Kalorik SVD 43056 BK Mode D'emploi

Fax +32 2 359 95 50


IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should
always be followed, including the following:
1. READ ALL INSTRUCTIONS BEFORE USE!
2. Check that the voltage in your home corresponds to that stated
on the appliance.
3. To protect against electrical shock, fire or personal injury,
submerse only the heater/pump portion of this sous vide
immersion cooker in liquid. DO NOT fill the water level past the
Maximum fill line. Do NOT immerse the upper section of the
machine in water or other liquid.
4. If the sous vide immersion cooker or power cord falls into liquid,
unplug the power cord from the electrical outlet immediately.
DO NOT REACH INTO THE LIQUID.
5. To disconnect, press the Start/Stop key for 2 seconds to stop
heating and remove the plug from wall outlet.
6. Never operate the machine without the machine clamped to a
sturdy surface, like a stock pot.
7. Do not permanently mount to any surface.
8. Do not let this sous vide immersion cooker in direct contact with
food. All foods to be prepared with this appliance should be
placed in food-grade freezer bags or boiling bags such as
vacuum-sealed bags.
9. This immersion cooker is intended for indoor use only; do not use
outdoors.
10. Close supervision is necessary when any appliance is used by or
near children. As a rule, this appliance is not intended to be used
by children.
11. Unplug from outlet when not in use and before cleaning. Allow to
cool before putting on or taking off parts.
12. Do not use an extension cord with this sous vide immersion
cooker.
13. Do not let the cord hang over the edge of a table or counter, or
touch hot surfaces.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity. Print only what is inside the frame.
2
Assembly page 2/44
SVD 43056 - 120501