Kohler K-99695 Mode D'emploi page 8

3. Connect the Components
IMPORTANT! Make drip loops in all cables.
IMPORTANT! Disconnect the power from the controller before
connecting the cables.
If not already installed, install any digital interfaces, digital
valves, and optional components for your system configuration.
Route all component cables to the controller location.
Gently press each connection into the proper port until it fully
clicks in place.
Connect the power supply to the controller. Verify that the digital
interface(s) illuminate.
Before Operating the System For the First Time:
Download and install the latest software for connected components.
This may take an hour or more to complete based on system
configuration and internet connection speed. Do not disconnect the
power from the controller during software download and
installation.
Refer to the "Download/Install Software" section for download
instructions.
1218131-2-A
Power Cord
Status LED
Ethernet
Wi-Fi (Future Expansion)
Digital Interface(s) and
Optional Components
Digital Mixing Valve(s)
8 Kohler Co.