Kohler K-99695 Mode D'emploi page 15

Troubleshooting (cont.)
Controller Troubleshooting Table
Symptoms Probable Cause
2. System stops A. Power supply
working and
the Status LED
is OFF.
B. Incorrect wiring of
3. Components A. Damaged cables or
are sometimes
not on the
menu, even
though they
are connected
to the
controller.
B. Power fluctuation.
C. The device is not
Interface Troubleshooting Table
Symptoms Probable Cause
1. Interface is not A. Controller is not
lit.
B. Interface cable
C. Circuit breaker has
Kohler Co.
Recommended Action
A. Reboot the controller
failure. by disconnecting the
AC power from the
wall outlet. If there is
no change after
reboot, replace the
power supply.
B. Verify that the
the AC power controller was
supply. installed per the
installation manual.
Make sure AC power
is present at the
outlet the controller
is plugged into.
A. Check all wiring
incorrect cable connections.
installation.
B. Verify that the
devices are
connected to a stable
power supply.
C. See peripheral device
installed correctly. owners manual.
Recommended Action
A. Plug the controller
plugged into the into an electrical
electrical outlet. outlet.
B. Check all interface
connections may cable connections.
be loose or
disconnected.
C. Reset the circuit
been tripped. breaker.
15 1218131-2-A