Components; Control Panel Components - Westinghouse WGen5300cv Mode D'emploi

COMPONENTS

CONTROL PANEL COMPONENTS

1
1. Run/Stop Switch: Push to Run position to start or
Stop position to shut the generator off.
2. Data Center: Toggle to show voltage, frequency,
total hour meter, and run/maintenance timer.
3. Main Circuit Breaker: The main circuit breaker
controls total output of all outlets to protect the
generator from overload or short circuit.
4. Voltage Selector Switch: Select 120 Volts or 240
Volts. Shut the generator OFF before switching
voltages.
5. 120/240 Volt AC, 30 Amp NEMA L14-30R Twist
Lock Receptacle: Receptacle can supply either
120V or 240V output.
6. 120 Volt AC, 30 Amp NEMA TT-30R Receptacle:
Receptacle can supply a maximum of 30 Amps.
DATA CENTER
Voltage:
Displays current voltage
output.
2 3
11
Frequency (Hz):
Displays power output
frequency in Hertz.
Push the Mode button to cycle through
the data display modes.
Mode Button
COMPONENTS
6
4 5
10
9
7. 120 Volt AC, 20 Amp Duplex NEMA 5-20R
Receptacles: Receptacles can supply a maximum of
20 Amps.
8. 20 Amp AC Circuit Breaker: Circuit breaker limits
the current that can be delivered through the NEMA
5-20R receptacles to 20 Amps.
9. 30 Amp AC Circuit Breaker: Circuit breaker limits
the current that can be delivered through the TT-
30R receptacle to 30 Amps.
10. Ground Terminal: The ground terminal is used to
externally ground the generator.
11. CO Sensor indicator lights: The CO Sensor
monitors for the accumulation of poisonous carbon
monoxide gas. If increasing levels of CO gas are
detected, the CO Sensor automatically shuts down
the engine.
Lifetime Hours:
Displays the lifetime run
hours.
Westinghouse Outdoor Power Equipment, LLC | 9
8
Run Time/Maintenance:
Displays current run time.
Resets to zero when shut
down. Maintenance
reminder displayed
when required.
7 7