Fujitsu Ten ECLIPSE CD5000 Manuel D'utilisation page 73

Setting the steering switch function (U.S.A. only)
The vehicle's factory loaded steering switch becomes inoperable when the CD5000 is installed. The
ECLIPSE web site (E-iSERV) provides software that enables steering switch operation even with
the installation of the main unit. Import this software into your CD5000. For details, contact the store
from which you purchased your main unit. Depending on your vehicle's make and model, material
downloaded from the web site may not be compatible with your steering switch.
Software for the steering switch can be downloaded and imported into the main unit as follows:
Access The ECLIPSE Website. (URL : http://www.e-iserv.jp)
Download the steering switch software following instructions provided
on the ECLIPSE web site (E-iSERV). (Because material available on
the web site may not be compatible with the steering switches found
on some automobiles, make sure to check the web site for details
about compatibility.)
Copy the downloaded software to CD-R or Memory Stick.
Import the data into the main unit from the CD-R or Memory Stick.
(For details of importing into the main unit, see page 71.)
The steering switch can be operated.
ATTENTION
Consult the store from which you purchased your CD5000 about compatibility and set-up
procedures.
Making changes with Function Mode
XIII
73