INFOSEC UPS SYSTEM X2 LCD TOUCH 500 Notice D'utilisation page 12

for natural discharging. UPS backup time will depend on the powered load, as well as the
age and condition of the batteries.
WARNING!
Batteries should always be replaced by qualified technicians. Batteries have a very high
short circuit current: connection errors could cause electric arcs resulting in
serious burns.
1 0 . T R O U B L E S H O O T I N G
Should the UPS fail to function correctly we recommend you perform the following tests
before calling the Hot Line.
Check list:
 Is the main switch in the "ON" position?
 Is the UPS plugged into the mains power supply?
 Does the power supply fall within specified unit values?
 Is the UPS overloaded?
 Is the battery flat or defective?
Fault condition
Output short
circuited
Overload fault
Overcharge
Bad or severely
discharged
battery
High output
voltage fault
Over-temperature
INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
12
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 04 15 AA 59 205 04
LCD Solutions
Disconnect short-circuited
loads and restart the UPS
again.
Disconnect all output loads
and restart the UPS again.
Make a service call
immediately.
Please replace the battery.
Make a service call
immediately.
1.
2.
Turn off the unit and
wait for it to cool.
Or remove excessive
loads and wait for it to
cool.