Table des Matières
Publicité
www.raider.bg
16
The cordless drill is equipped with an electronic brake that stops the spindle immediately after
releasing the breaker (1). The brakes guarantee torque and drilling accuracy and do not allow
free spindle rotation after shutdown.
5.4. Adjusting the speed of rotation.
The speed of drilling or drilling can be adjusted during operation by increasing or decreasing the
pressure of the trigger button (1). Speed adjustment enables a slow start, which, when drilling
openings in plaster or smooth and polished surfaces, prevents the drill from slipping, while
turning and unwinding helps control the process.
5.5. Protective connector. Torque control.
Placing the ring (7) in the selected position causes the clutch to be locked to a certain torque
value. Once the set point has been reached, the safety clutch is automatically switched off. This
prevents the screw from turning too deep.
For different screws and different materials different torque values apply.
The moment is larger, the larger the number corresponding to the given position.
The ring (7) is set to a specified torque value.
We recommend that you start lower-torque operation.
The torque should be increased gradually until the desired result is obtained.
To unscrew screws, larger values must be selected.
To drill holes, the setting marked with a drill bit must be selected. With this setting, the cordless
drill works at the highest torque value.
The ability to select the setting is gained with practice.
Setting the ring in the drilling position causes the safety coupling to be deactivated.
5.6. Shifting speeds.
The battery drill has a velocity switch (6) enabling the torque range to be increased when the
torque is changed.
I Speed: lower revs, higher torque;
II Speed: higher revs, lower torque.
Depending on the operation, the gear selector must be set to the appropriate position. If it can
not be moved, the spindle must be slightly rotated.
Do not change the position of the gearshift during operation of the cordless drill. This will cause
damage to the power tool.
5.7. Placing the work tool.
Move the direction switch (2) to the center position.
Turning the ring on the single-hand chuck to the right produces the desired opening of the jaws
required to fit a drill or nozzle.
The drill or tip is inserted in the hole of the chuck. When the ring is turned to the left, the jaws
are closed. Tighten firmly.
The tool is disassembled in a sequence opposite to its installation.
When attaching the drill or nozzle to the chuck, attention must be paid to the correct orientation
of the tool. When using short screwdriver bits or bits, an additional magnetic extension should
be used.
5.8. Direction of rotation left and right.
The direction of rotation of the spindle is selected by means of the direction switch (2).
Rotate to the right - set the switch (2) to the extreme left position.
Rotate left - set the switch (2) to the far right position.
It is not allowed to change the direction of rotation when the spindle of the cordless drill rotates.
5.9. Drilling.
When a large diameter hole is to be drilled, it is recommended to drill a smaller hole first, then
be punched to the desired size. This will prevent overloading the drill. Drilling of deep holes
should be done gradually by removing the bore from the hole periodically to remove chips or
dust. If the drill bit lands in the hole during drilling, the drill must be stopped immediately. Use
the change of rotation direction to remove the drill from the hole. The drill must be aligned with
Publicité
Table des Matières
