Important Safety Instructions - Fluval FX6 Guide De L'utilisateur

Masquer les pouces Voir aussi pour FX6:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT SAFETY INSTRUCTIONS

WARNING - To guard against injury, basic safety precautions should be observed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
To guard against injury, basic safety precautions should be observed when handling the Fluval Canister
1. READ & FOLLOW ALL SAFETY INSTRUCTIONS and all the
important notices on the appliance before using. Failure to
do so may result in the loss of fish life and/or damage to
the appliance.
2. DANGER – To avoid possible electric shock, special
care should be taken since water is employed in the
use of aquarium equipment. For each of the following
situations, do not attempt repairs yourself, return the
appliance to an authorized service facility for service or
discard the appliance.
A. If the appliance falls into the water, DON'T reach
for it! First unplug it and then retrieve it. If electrical
components of the appliance get wet, unplug the
appliance immediately.
B. If the applicance shows any sign of abnormal water
leakage or if RCD (or GFCI – Ground Fault Current
Interrupter) switches off disconnect the power supply
cord from the mains and remove pump from water.
C. Carefully examine the appliance after installation. It
should not be plugged if there is water on parts not
intended to be wet.
D. Do not operate any appliance if it has a damaged
cord or plug, or if it is malfunctioning or it is dropped
or damaged in any manner. The power cord of this
appliance cannot be replaced. If the cord is damaged,
the appliance should be discarded. Never cut the cord.
E. To avoid the possibility of the appliance plug or
receptacle getting wet, position the appliance to one
side of a wall mounted receptacle. To prevent water
from dripping onto the receptacle or plug, a "drip loop"
(see photo) should be arranged by the user in the cord
connecting appliance to a receptacle. The "drip loop" is
that part of the cord below the level of the receptacle or
the connector, to prevent water travelling along the cord
and coming in contact
with the receptacle. If the
plug or receptacle does
get wet, DON'T unplug
the cord. Disconnect the
fuse or circuit breaker
that supplies power to the
appliance. Then unplug
and examine for presence
of water in receptacle.
3. WARNING – Close supervision is necessary when any
appliance is used by or near children. This appliance is not
intended for use by persons (including children) with reduced
EN-2
Filter, including the following:
physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to
ensure that they do not play with the appliance.
4. To avoid injury, do not touch moving parts or hot parts.
5. CAUTION – Always unplug or disconnect all appliances
in the aquarium from electricity supply before placing
hands in water, before putting on or taking off parts and
while the equipment is being installed, maintained or
handled. Grasp the plug and pull to disconnect. Never
yank cord to pull plug from outlet. Always unplug an
appliance from an outlet when not in use.
6. This appliance is not a submersible aquarium filter-pump.
It is intended for use in ornamental household aquariums.
It may be used with fresh or salt water. Maximum water
temperature 35°C. Do not use this appliance for other than
intended use (i.e.: do not use in swimming pools, bathrooms,
etc.). The use of attachments not recommended or sold by
the appliance manufacturer may cause an unsafe condition
and will invalidate your warranty. Do not use this appliance:
a. In swimming pools or other situations where people are
immersed;
b. With inflammable or drinkable liquids.
7. This is a HOUSEHOLD APPLIANCE INTENDED FOR
DOMESTIC USE and it is suitable for INDOOR use only. Do
not install or store this appliance where it will be exposed to
the weather or temperatures below freezing.
8. Make sure that this appliance is securely installed before
operating it and that the electrical connection is in
accordance with the data on the rating label. Do not allow
filter pump to run dry.
9. If an extension cord is necessary, a cord with proper rating
should be used. A cord rated for less amperes or watts than
the appliance rating may overheat. Care should be taken to
arrange the cord so that it will not be tripped over or pulled.
The connection should be carried out by a qualified electrical
installer.
SAVE THESE INSTRUCTIONS
10.
for future reference.

Publicité

Table des Matières
loading

Table des Matières