Installation And Use - Fluval FX6 Guide De L'utilisateur

IMPORTANT: Read all instructions before beginning.
DO NOT PLUG IN FILTER UNTIL SETUP IS COMPLETE AND UNIT IS FILLED WITH WATER.
Use the diagram on the inside front cover as a guide.
1. Decide on filter placement. Remember, this is a gravity-fed system. For it to work properly, all the
Installation Requirements below must be adhered to.
Installation Requirements
4.9 ft. (150cm). NEVER install the filter above the water level.
IMPORTANT: The hosing supplied with the unit
is 13.1 ft (4m) long. If longer hosing is required,
intake hosing must not exceed 6.5 ft. (2m) and
the total length of intake and outlet hosing
combined must not exceed 16.4 ft. (5m).
filter to the aquarium rim, with no slack and
no loops.
(20 cm) below your aquarium rim.
beneath the aquarium (as in figure shown).
attach the supplied hosing without moving the unit.

INSTALLATION AND USE

<20 cm (7.8".)
<20 cm (7.8") to
< 150 cm (4.9')
EN-7