Replacing The Carbon Brushes - Meec tools 011639 Mode D'emploi

EN
3. Replace the cap and tighten with the
spanner.
FIG. 5
FIG. 6

REPLACING THE CARBON BRUSHES

The motor switches off automatically when
the insulated resin tip in the carbon brush
comes into contact with the commutator.
Replace both carbon brushes when this occurs.
Keep the carbon brushes clean so that they
slide easily in the holders. Both carbon brushes
should be replaced at the same time. Only use
carbon brushes of the same type.
1. Commutator
2. Insulated tip
3. Carbon brush
FIG. 7
24