Lubrication - Meec tools 011639 Mode D'emploi

WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
Robust demolition hammer. The following
accessories are included:
• Flat chisel 30x140 mm
• Pointed chisel 30x140 mm
• Transport case with roller
• Extra handle
• VDE plug and cord
USE
WARNING!
• Check that the mains voltage
corresponds to the rated voltage on the
type plate.
• Switch off the product, pull out the plug
and wait until all moving parts have
completely stopped before adjusting,
replacing parts, cleaning and/or carrying
out maintenance.
• Check that there are no electrical cables,
gas and/or water pipes in the work
area.
BITS
The product has a quick chuck for SDS-Max
bits. The product is supplied with two bits. Fit
the bits as shown in the diagrams.
FIG. 1
FIG. 2
STARTING/STOPPING
Press the power switch to start the product,
and release to stop.
FIG. 3
HOW TO USE
IMPORTANT:
Use suitable safety equipment.
Hold the product firmly with both hands as
shown in the diagram. ALWAYS use the extra
handle.
FIG. 4
MAINTENANCE
WARNING!
Switch off the product and pull out the plug
before checking, cleaning, maintenance
or adjustments, and before changing
accessories.

LUBRICATION

The product does not require daily lubrication.
The product should be lubricated after
6 months of use.
1. Switch off the product and pull out the
plug.
2. Remove the cap (1) with a 23 mm spanner
(2) and fill up with new grease (60 g). Do
not overfill, this can cause malfunctioning
and/or damage the product.
EN
23