Technical Data - Meec tools 018279 Mode D'emploi

EN

TECHNICAL DATA

Rated voltage
Battery capacity
Speed
Cutting width
Weight
Sound pressure level, LpA 76.5 dB(A), K= 3 dB
Sound power level, LwA*
Sound power level, LwA**
Max vibration level
*Measured, **Guaranteed
Always wear ear protection.
The declared vibration value, which has been
measured by a standardised test method, can be
used to compare different tools with each other
and for a preliminary assessment of exposure.
The measurement values have been determined
in accordance with EN 50636.2.91:2014.
WARNING!
The actual vibration level when using power
tools may differ from the specified maximum
value, depending on how the tool is used.
It is therefore necessary to determine which
safety precautions are required to protect
the user, based on an estimate of exposure
in actual operating conditions (taking into
account all stages of the work cycle, e.g. the
time when the tool is switched off and when
it is idling, in addition to the start-up time).
DESCRIPTION
1. Top shaft
2. Bottom shaft
3. Handle
4. Carry strap
5. Guard
50
40 VDC
5 Ah
5000 rpm
255/380 mm
3.8 kg
88 dB(A), K= 3 dB
92 dB(A)
1.58 m/s², K= 1.5 m/s²
6. Trimmer head
7. Clearing blade
8. Clips
9. Tools
FIG. 1
ASSEMBLY
IMPORTANT:
Do not put in the battery before the product
is fully assembled and adjusted. Wear safety
gloves when working on the product. Unpack
the product and check that all the parts are
included and undamaged.
FITTING THE SHAFT
FIG. 2
FIG. 3
FITTING THE HANDLE
1. Release the knob that holds the fastener
closed.
FIG. 4
2. Put the handle in the fastener.
FIG. 5
3. Tighten the knob to hold the handle firmly
in place.
FIG. 6
FITTING THE GUARD
Fit the guard on its holder with three screws.
Firmly tighten the screws.
FIG. 7
FIG. 8