elem Garden Technic ASB3000-16 Traduction Des Instructions D'origine page 17

Connect the power cord (Fib.4)
- secure cables to the existing cable strain relief. (Fig.6)
- Connect the power cord. (Fig.6)
Before Operation
Before using the leaf vacuum / blower in operation,
connect using a residual current device (RCD) the leaf
vacuum / blower to the power network and turn on the
device. Check that the residual current device (RCD)
works
Turning on the Leaf Blower. (Fig.5)
Before turning on the leaf vacuum / blower, make sure
that the suction and blow pipe is properly seated.
Warning! Before you choose the suction or blowing mode
you must make sure that the mode lever is easy to
operate and is not obstructed by debris of a previous
application
.
Use select the selector lever (Fig. 5) (5.1) (5.2) to either
the suction or blowing function. Press the on / off switch
to activate the device (Fig. 6, Pos. 6.1).
Turn the speed controller (7.1) of "1" to "Max", if you
need more power. (Fig. 7, Pos. 7.1).
Important
Both switches (Fig. 6, Pos. 6.1) are on / off switch. Press
a down, the other is pressed automatically.
Using the leaf vacuum.
Do not try to pick up moist small parts, let foliage dry it
before you use the leaf vacuum / blower.
The leaf vacuum / blower can be used to blow away to
small parts of courtyards, paths, driveways, lawns,
shrubs and corners. It can also be leaves, pieces of
paper, small branches and pieces of wood pick.
If you / blowers in vacuum mode use the leaf vacuum,
the small parts are sucked up through the suction pipe,
the pass Vacuum fan partially crushed and thrown into
the waste-collection bag. The shredded organic wastes
are ideal around as mulch around plants. Warning! Hard
objects such as stones, cans, glass, etc. damage the
vacuum fan.
Important
Use the leaf vacuum / blower not to absorb water or very
wet hardware.
Take the leaf vacuum / blower never in operation when
the waste-collection bag is not attached.
In the case of an accident or malfunction, turn off the
power immediately, unplug the power cord and make
sure that all moving parts are completely still. Then
check etc. If you have the device any question, please
contact the dealer.
Seite 17 von 36